Which of the following types of Ethernet cables are designed for reduced signal interference quizlet?

Introduction to Algorithms

3rd EditionCharles E. Leiserson, Clifford Stein, Ronald L. Rivest, Thomas H. Cormen

726 solutions

Information Technology Project Management: Providing Measurable Organizational Value

5th EditionJack T. Marchewka

346 solutions

Service Management: Operations, Strategy, and Information Technology

7th EditionJames Fitzsimmons, Mona Fitzsimmons

103 solutions

Information Technology Project Management: Providing Measurable Organizational Value

5th EditionJack T. Marchewka

346 solutions

Algebra and Trigonometry

5th EditionRobert F. Blitzer

10,851 solutions

Calculus

7th EditionBruce H. Edwards, Larson, Robert P. Hostetler

10,461 solutions

Algebra and Trigonometry with Analytic Geometry

12th EditionEarl W. Swokowski, Jeffery A. Cole

6,464 solutions

Trigonometry

10th EditionCallie Daniels, David I. Schneider, John Hornsby, Margaret L. Lial

3,591 solutions

Pins 1, 2, 4, and 5 are connected to 4, 5, 1, and 2.

A T1 cable uses pairs 1 and 2, so connecting two T1 CSU/DSU devices back-to-back requires a crossover cable that swaps these pairs. Specifically, pins 1, 2, 4, and 5 are connected to 4, 5, 1, and 2, respectively.

1 > 3, 2 > 6, 3 > 1, and 6 > two

A crossover cable is used to connect a computer to another computer, a hub to a switch, a hub to another hub, a switch to another switch, and a router to another router. The Crossover cable has eight wires inside the cable shield and two RJ-45 connectors at each end. In the crossover cable, two sets of wires are crossed over. The correct pin mapping of an Ethernet crossover cable is 1 > 3, 2 > 6, 3 > 1, and 6 > 2.